Tensile Fabric Structures International Company

The load bearing in the tension fabric structures can be generalised as follows:
1 The dead load of the architecture membrane structures is very much less than 50 n/m2.
2 Roof live loads are not relevant to tensile fabric structures but there are typically designed for normal loads.
3 Seismic load not applicable because of low mass.
4 Wind [...]

Tension fabric structures may be designed by the designer and build approach or by engineering consultant with specilialized knowledge in this tensile fabric structures technology. Normally architects will provide general parameters and let the tensile membrane specialist to to provide details engineering and connection solution.
Building tensile fabric structures can become problematic when owners and constructors [...]

Tensile fabric structures featured in the Press Release. We are pround that we are recognise tension fabric structures in the market.
This guide is very useful to someone who is new in the tensile fabric structures. This is a good guide for architect, designer and owner.
Click here to read the details: Press Release

This is a preliminary method statement for fabric structures, and therefore the content is set out in a basic format.
The erection statement for architectural fabric structuresthat will accompany this project.
The erection statment for tensile fabric structures is significantly more detailsand comprehensive drawings.

1. Erect steel columns and lift beam / trusses into place;
2. [...]

link here

The demo of Kurvenbau lightweight structure design software Tess3D showing how the tensile fabric structures design process. How to develop the fabric structure from sketch to 3D structures. As part of the analysis where the sun shade, rain load, snow load and wind load serve as a important factor in the design development process of [...]

Form finding in tensile fabric structures is the process finding a balance and reasonable geometry and suitable shape for a design because the fabric membrane is flexible.
Membrane used in fabric structures are structural element. Due to the fabric used in the tensile fabric structures the structural membrane under went changes of shape and form under [...]

Pictures from forum of chinese steel construction in tensile fabric structures and tensile world.
Beijing’s National Swimming Center - The Water Cube
Seating capacity - 17,000
Gross floor area - 70,000m²
Structure - size 177×177×31m, there are 22,000 steel members and 12,000 nodes, is made of 6,500 tonnes of steel
There are 4,000 bubbles(ETFE cushions) with the maximum bubble diameter [...]

Pictures from forum of chinese steel construction in tensile fabric structures and tensile world.
Beijing National Stadium
Seating capacity - 80,000
Total site area - 204,278m²
Gross floor area - 258,000m²
Structure - 36km of unwrapped steel length
Height - 69.2m above pitch level
The steel roof, a single 330m long by 220m wide structure, weighing 45,000 tonnes
Design consortium
Herzog & de Meuron [...]